P07B4 — Park position sensor/switch A: signal too high
| Meaning | The transmission control unit is receiving a higher voltage than expected from Park position sensor or switch "A". This usually points to a short to the power supply or a faulty sensor. The exact value and the sensor's location depend on the make. |
| Family | Powertrain (P) |
Typical symptoms
Wrong gear indication on the dashboard
Lever not releasing from Park
Odd reverse light behaviour
Transmission or engine warning light on
Gearbox in limp mode
Common causes
Sensor connector with moisture or corrosion
Faulty position sensor or switch
Sensor out of adjustment relative to the lever
Worn selector lever or linkage
Fault in the transmission control unit
What to do
How to read code P07B4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07B4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (B4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07B4 mean?
Park position sensor/switch A: signal too high. The transmission control unit is receiving a higher voltage than expected from Park position sensor or switch "A". This usually points to a short to the power supply or a faulty sensor. The exact value and the sensor's location depend on the make.
Can I keep driving with code P07B4 active?
With caution: limp mode possible, have it checked soon
Common causes — P07B4
Wiring with damaged insulation touching the power supply Sensor connector with moisture or corrosion Faulty position sensor or switch Sensor out of adjustment relative to the lever Worn selector lever or linkage Fault in the transmission control unit
How do you fix code P07B4?
First check the sensor wiring and connector for moisture, corrosion or damaged wires. If the car will not start or the lever jams, go to a workshop. Always apply the handbrake as well when parked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07B3 — Park position sensor/switch A: signal too low
- Next code: P07B5 — Park position sensor/switch A: implausible signal,...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible