P07B7 — Transmission Park position sensor A: intermittent signal
| Meaning | The transmission control unit detected that the signal from the Park position sensor or switch (circuit A) drops in and out or changes erratically. The system cannot be sure whether the selector is really in Park. The fault may only show up at times, for example with vibration or moisture. |
| Family | Powertrain (P) |
Typical symptoms
The car sometimes will not start, or starts only after moving the selector
The gear indicator on the dash flickers or changes by itself
Trouble removing the key or switching off the ignition
Transmission going into a protective limp mode
Common causes
Wire in the transmission harness chafed or damaged
Worn Park position sensor or switch
Oil or moisture inside the connector
Selector linkage out of adjustment
Faulty transmission control unit, which is rare
What to do
How to read code P07B7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07B7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (B7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07B7 mean?
Transmission Park position sensor A: intermittent signal. The transmission control unit detected that the signal from the Park position sensor or switch (circuit A) drops in and out or changes erratically. The system cannot be sure whether the selector is really in Park. The fault may only show up at times, for example with vibration or moisture.
Can I keep driving with code P07B7 active?
With caution: limp mode possible, have it checked soon
Common causes — P07B7
Corroded or loose sensor connector Wire in the transmission harness chafed or damaged Worn Park position sensor or switch Oil or moisture inside the connector Selector linkage out of adjustment Faulty transmission control unit, which is rare
How do you fix code P07B7?
First check the sensor connector and wiring, flexing them gently while a technician watches the signal on a scan tool. While the fault is present, do not rely on Park alone: always apply the handbrake when you park. Have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07B6 — Park position sensor/switch A: implausible signal,...
- Next code: P07B8 — Transmission Park position sensor B: open circuit
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible