P07B8 — Transmission Park position sensor B: open circuit
| Meaning | The transmission control unit receives no signal at all from Park position sensor or switch B, as if the circuit were broken. Sensor B is the second sensor that monitors the Park position, and without it the system loses its cross-check. The control unit may limit some functions as a precaution. |
| Family | Powertrain (P) |
Typical symptoms
The car will not start, or starts only in Neutral
The P indication on the dash does not appear
Trouble removing the key from the ignition
Transmission going into a protective limp mode
Common causes
Broken wire in the transmission harness
Faulty Park position sensor or switch
Missing power or ground supply to the sensor
Faulty transmission control unit, which is rare
What to do
How to read code P07B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07B8 mean?
Transmission Park position sensor B: open circuit. The transmission control unit receives no signal at all from Park position sensor or switch B, as if the circuit were broken. Sensor B is the second sensor that monitors the Park position, and without it the system loses its cross-check. The control unit may limit some functions as a precaution.
Can I keep driving with code P07B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P07B8
Sensor connector unplugged or corroded Broken wire in the transmission harness Faulty Park position sensor or switch Missing power or ground supply to the sensor Faulty transmission control unit, which is rare
How do you fix code P07B8?
Have the connector and wiring of sensor B checked, and confirm that power and ground reach the sensor. Do not keep driving for long with the fault present: if Park is not recognized, always use the handbrake when stopped.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07B7 — Transmission Park position sensor A: intermittent...
- Next code: P07B9 — Transmission Park position sensor B: signal too lo...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible