Skip to content
Fault code dictionary (DTC)

P07BA — Transmission Park position sensor B: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a higher than normal voltage on the Park sensor B circuit. This usually points to a short to power, a failed internal contact, or damaged wiring. The Park position cannot be confirmed reliably.
FamilyPowertrain (P)

Typical symptoms

Transmission or check engine light on
Engine will not start, or starts only in certain selector positions
Wrong gear indication on the dash
Selector position seems not to be recognized
Transmission in limp mode

Common causes

Sensor wire shorted to power
Faulty Park position sensor or switch
Damaged connector or dirty contacts
Rubbed-through harness touching another wire
Faulty transmission control unit, which is rare

What to do

Have the sensor B wiring and connector checked and the signal voltage measured with the selector in Park. While the fault is present, always apply the handbrake when leaving the car stationary.

How to read code P07BA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P07BA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (BA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P07BA mean?

Transmission Park position sensor B: signal too high. The control unit measured a higher than normal voltage on the Park sensor B circuit. This usually points to a short to power, a failed internal contact, or damaged wiring. The Park position cannot be confirmed reliably.

Can I keep driving with code P07BA active?

With caution: limp mode possible, have it checked soon

Common causes — P07BA

Sensor wire shorted to power Faulty Park position sensor or switch Damaged connector or dirty contacts Rubbed-through harness touching another wire Faulty transmission control unit, which is rare

How do you fix code P07BA?

Have the sensor B wiring and connector checked and the signal voltage measured with the selector in Park. While the fault is present, always apply the handbrake when leaving the car stationary.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes