P07BB — Transmission Park position sensor B: performance, signal low
| Meaning | The Park sensor B signal is present, but stays lower than the control unit expects for the selector position. The circuit is not necessarily broken: the value is simply not believable. It may come from the sensor, a wrong adjustment, or an electrical problem. |
| Family | Powertrain (P) |
Typical symptoms
Engine sometimes refuses to start
Park indication missing or delayed
Uncertain gear changes
Transmission limp mode
Common causes
Aged or out-of-calibration Park position sensor
Abnormal resistance in the wiring or connector
Corrosion on the contacts
Sensor installed incorrectly after transmission work
Faulty transmission control unit, which is rare
What to do
How to read code P07BB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07BB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (BB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07BB mean?
Transmission Park position sensor B: performance, signal low. The Park sensor B signal is present, but stays lower than the control unit expects for the selector position. The circuit is not necessarily broken: the value is simply not believable. It may come from the sensor, a wrong adjustment, or an electrical problem.
Can I keep driving with code P07BB active?
With caution: limp mode possible, have it checked soon
Common causes — P07BB
Selector or linkage not adjusted correctly Aged or out-of-calibration Park position sensor Abnormal resistance in the wiring or connector Corrosion on the contacts Sensor installed incorrectly after transmission work Faulty transmission control unit, which is rare
How do you fix code P07BB?
Have the selector adjustment and the condition of the connector and wiring checked first, then have the values of sensors A and B compared on a scan tool. Until it is repaired, always use the handbrake when stopped.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07BA — Transmission Park position sensor B: signal too hi...
- Next code: P07BC — Transmission Park position sensor B: performance,...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible