P07BC — Transmission Park position sensor B: performance, signal high
| Meaning | The Park sensor B signal is present, but stays higher than the control unit expects for the selector position. The value does not match what is expected, even though the circuit is not completely broken. The cause may be the sensor, the adjustment or the wiring. |
| Family | Powertrain (P) |
Typical symptoms
Uncertain or refused engine start
Wrong selector position displayed
Transmission seems not to recognize Park
Transmission limp mode
Common causes
Out-of-calibration or worn Park position sensor
Abnormal resistance or dirty contact in the connector
Partly damaged harness
Sensor installed incorrectly after work
Faulty transmission control unit, which is rare
What to do
How to read code P07BC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07BC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (BC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07BC mean?
Transmission Park position sensor B: performance, signal high. The Park sensor B signal is present, but stays higher than the control unit expects for the selector position. The value does not match what is expected, even though the circuit is not completely broken. The cause may be the sensor, the adjustment or the wiring.
Can I keep driving with code P07BC active?
With caution: limp mode possible, have it checked soon
Common causes — P07BC
Selector or linkage adjusted incorrectly Out-of-calibration or worn Park position sensor Abnormal resistance or dirty contact in the connector Partly damaged harness Sensor installed incorrectly after work Faulty transmission control unit, which is rare
How do you fix code P07BC?
Have the selector adjustment and the condition of the connector and wiring checked, then have the values of sensors A and B compared. While the code is present, do not rely on Park alone and use the handbrake.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07BB — Transmission Park position sensor B: performance,...
- Next code: P07BD — Transmission Park position sensor B: intermittent...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible