P07BE — Transmission Park position sensors A and B: signals disagree
| Meaning | The control unit compares the two sensors that report the Park position and found that they do not give the same information. It therefore cannot tell which one is right. The fault may lie in one of the sensors, in the wiring, or in the mechanical adjustment of the selector. |
| Family | Powertrain (P) |
Typical symptoms
Engine refuses to start or starts unreliably
Wrong gear indication on the dash
Selector looks to be in Park but is not recognized
Transmission limp mode
Common causes
One of the two sensors faulty or out of calibration
Connector or wiring with abnormal resistance
Corrosion in the contacts
Sensors installed incorrectly after transmission work
Faulty transmission control unit, which is rare
What to do
How to read code P07BE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07BE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (BE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07BE mean?
Transmission Park position sensors A and B: signals disagree. The control unit compares the two sensors that report the Park position and found that they do not give the same information. It therefore cannot tell which one is right. The fault may lie in one of the sensors, in the wiring, or in the mechanical adjustment of the selector.
Can I keep driving with code P07BE active?
With caution: limp mode possible, have it checked soon
Common causes — P07BE
Selector or linkage adjusted incorrectly One of the two sensors faulty or out of calibration Connector or wiring with abnormal resistance Corrosion in the contacts Sensors installed incorrectly after transmission work Faulty transmission control unit, which is rare
How do you fix code P07BE?
Have the selector adjustment checked first, then have the values of both sensors read with a scan tool to see which one is off. Until it is resolved, always use the handbrake when parking.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07BD — Transmission Park position sensor B: intermittent...
- Next code: P07BF — Input shaft speed sensor A: signal low
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible