P07BF — Input shaft speed sensor A: signal low
| Meaning | The transmission control unit detected a signal that is too low from sensor A, which measures the speed of the input shaft, also called the turbine shaft. The control unit uses this reading to decide when and how to shift. If the signal is not reliable, the transmission may work less precisely. |
| Family | Powertrain (P) |
Typical symptoms
Harsh, late or mistimed shifts
Transmission stuck in one gear
Odd behaviour of the tachometer or speedometer
Transmission limp mode
Felt slipping under acceleration
Common causes
Corroded or loose connector
Faulty speed sensor
Metal debris on the sensor tip
Transmission fluid level or condition not correct
Faulty transmission control unit, which is rare
What to do
How to read code P07BF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07BF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (BF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07BF mean?
Input shaft speed sensor A: signal low. The transmission control unit detected a signal that is too low from sensor A, which measures the speed of the input shaft, also called the turbine shaft. The control unit uses this reading to decide when and how to shift. If the signal is not reliable, the transmission may work less precisely.
Can I keep driving with code P07BF active?
With caution: limp mode possible, have it checked soon
Common causes — P07BF
Sensor wiring damaged or shorted to ground Corroded or loose connector Faulty speed sensor Metal debris on the sensor tip Transmission fluid level or condition not correct Faulty transmission control unit, which is rare
How do you fix code P07BF?
Have the sensor wiring and connector checked first, then the level and condition of the transmission fluid. If the transmission is in limp mode or slipping, avoid pushing on with driving, as you could make the damage worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07BE — Transmission Park position sensors A and B: signal...
- Next code: P07C0 — Input shaft speed sensor A: signal high
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible