P07EA — Transmission range control circuit A: low signal
| Meaning | The transmission control unit read a lower voltage than allowed in range control circuit A. This often happens with a wire shorted to ground or a sensor that is not giving the correct signal. The exact meaning of A depends on the vehicle. |
| Family | Powertrain (P) |
Typical symptoms
The car does not engage or will not move
Gearbox in limp mode
Engine start refused in some positions
Transmission or check engine light on
Common causes
Faulty range sensor or selector
Damaged connector or moisture in it
Crushed or chafed wiring
Internal fault in the transmission control unit
What to do
How to read code P07EA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07EA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (EA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07EA mean?
Transmission range control circuit A: low signal. The transmission control unit read a lower voltage than allowed in range control circuit A. This often happens with a wire shorted to ground or a sensor that is not giving the correct signal. The exact meaning of A depends on the vehicle.
Can I keep driving with code P07EA active?
With caution: limp mode possible, have it checked soon
Common causes — P07EA
Circuit wire touching ground Faulty range sensor or selector Damaged connector or moisture in it Crushed or chafed wiring Internal fault in the transmission control unit
How do you fix code P07EA?
Have the wiring and connectors of the selector and the gearbox inspected, looking for moisture or damaged wires. If the problem stops the car from engaging or starting, do not use it until it is resolved.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07E9 — Transmission range control circuit A: performance
- Next code: P07EB — Transmission range control circuit A: high signal
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible