P07EB — Transmission range control circuit A: high signal
| Meaning | The transmission control unit read a higher voltage than allowed in range control circuit A. It can come from a short to supply voltage, a poor connection at certain points or a faulty sensor. The exact meaning of A depends on the vehicle. |
| Family | Powertrain (P) |
Typical symptoms
Uncertain or impossible engagement of some positions
Gearbox in limp mode
Engine will not start in some positions
Transmission or check engine light on
Common causes
Faulty range sensor or selector
Damaged or corroded connector
Wiring ruined by chafing or heat
Internal fault in the transmission control unit
What to do
How to read code P07EB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07EB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (EB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07EB mean?
Transmission range control circuit A: high signal. The transmission control unit read a higher voltage than allowed in range control circuit A. It can come from a short to supply voltage, a poor connection at certain points or a faulty sensor. The exact meaning of A depends on the vehicle.
Can I keep driving with code P07EB active?
With caution: limp mode possible, have it checked soon
Common causes — P07EB
Wire touching a supply voltage Faulty range sensor or selector Damaged or corroded connector Wiring ruined by chafing or heat Internal fault in the transmission control unit
How do you fix code P07EB?
First check the connectors and wiring of the selector, as they are the easiest causes to verify. If the gearbox does not engage or the car will not start, do not drive it until it is resolved.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07EA — Transmission range control circuit A: low signal
- Next code: P07EC — Transmission range multi-function select circuit
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible