P07EE — Transmission range multi-function circuit: range/performance
| Meaning | The control unit found that the signal from the multi-function range selection circuit is outside the expected values or inconsistent with the other gearbox data. The circuit is not necessarily broken, but the signal is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Uncertain or delayed engagement
Intermittent problem that sometimes goes away
Gearbox going into limp mode
Transmission or check engine light on
Common causes
Selector cable or linkage out of adjustment
Connectors with poor contact or corrosion
Partially damaged wiring
Internal fault in the transmission control unit
What to do
How to read code P07EE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07EE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (EE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07EE mean?
Transmission range multi-function circuit: range/performance. The control unit found that the signal from the multi-function range selection circuit is outside the expected values or inconsistent with the other gearbox data. The circuit is not necessarily broken, but the signal is not reliable.
Can I keep driving with code P07EE active?
With caution: limp mode possible, have it checked soon
Common causes — P07EE
Out-of-adjustment or worn multi-function range switch Selector cable or linkage out of adjustment Connectors with poor contact or corrosion Partially damaged wiring Internal fault in the transmission control unit
How do you fix code P07EE?
Have the selector adjustment and the connectors checked, as they are the most frequent cause of intermittent problems. If the gearbox tends not to engage, have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07ED — Transmission range multi-function circuit: stuck
- Next code: P07EF — Transmission range multi-function circuit: low sig...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible