P07EF — Transmission range multi-function circuit: low signal
| Meaning | The transmission control unit read a lower voltage than allowed in the multi-function range selection circuit. It often points to a wire shorted to ground or a switch that is not giving the correct signal. |
| Family | Powertrain (P) |
Typical symptoms
Gearbox not engaging in some positions
Engine will not start in Park or neutral
Gearbox in limp mode
Transmission or check engine light on
Common causes
Faulty multi-function range switch
Damaged connector or moisture in it
Crushed or chafed wiring
Internal fault in the transmission control unit
What to do
How to read code P07EF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07EF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (EF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07EF mean?
Transmission range multi-function circuit: low signal. The transmission control unit read a lower voltage than allowed in the multi-function range selection circuit. It often points to a wire shorted to ground or a switch that is not giving the correct signal.
Can I keep driving with code P07EF active?
With caution: limp mode possible, have it checked soon
Common causes — P07EF
Circuit wire touching ground Faulty multi-function range switch Damaged connector or moisture in it Crushed or chafed wiring Internal fault in the transmission control unit
How do you fix code P07EF?
Have the wiring and connectors of the range switch checked, looking for moisture or damaged wires. If the car does not engage or will not start, do not use it until it is resolved.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07EE — Transmission range multi-function circuit: range/p...
- Next code: P07F0 — Transmission range multi-function circuit: high si...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible