P07F1 — Input/turbine shaft speed sensor C circuit
| Meaning | The transmission control unit found a fault in the circuit of sensor C, which measures the speed of the input shaft or the torque converter turbine. Without this data the unit cannot properly work out slip and shift timing. Which sensor is exactly C depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Inconsistent speedometer or gear indicator
Gearbox stuck in one gear (limp mode)
Engine revs rising without drive
Transmission or check engine light on
Common causes
Damaged sensor connector or wiring
Metal debris in the oil disturbing the sensor
Dirty transmission fluid or incorrect level
Damaged reluctor ring or tone wheel
Internal fault in the transmission control unit
What to do
How to read code P07F1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07F1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (F1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07F1 mean?
Input/turbine shaft speed sensor C circuit. The transmission control unit found a fault in the circuit of sensor C, which measures the speed of the input shaft or the torque converter turbine. Without this data the unit cannot properly work out slip and shift timing. Which sensor is exactly C depends on the manufacturer.
Can I keep driving with code P07F1 active?
With caution: limp mode possible, have it checked soon
Common causes — P07F1
Faulty speed sensor Damaged sensor connector or wiring Metal debris in the oil disturbing the sensor Dirty transmission fluid or incorrect level Damaged reluctor ring or tone wheel Internal fault in the transmission control unit
How do you fix code P07F1?
Check the sensor connector and wiring and the condition of the transmission fluid. If the gearbox has gone into protection mode, avoid long drives and have the car checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07F0 — Transmission range multi-function circuit: high si...
- Next code: P07F2 — Transmission range control module communication ci...
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible