P07F2 — Transmission range control module communication circuit
| Meaning | The control unit has lost, or is not correctly receiving, communication with the module that controls gearbox range selection. This module is mainly found on cars with an electronic selector. Without reliable communication, the gearbox may not carry out the driver's commands. |
| Family | Powertrain (P) |
Typical symptoms
Gearbox error messages on the dashboard
Gear indicator missing or wrong
Engine will not start or the car will not move
Several warning lights on together, even ones unrelated to the gearbox
Common causes
Damaged wiring or connectors in the data network
Faulty or corroded ground connection
Faulty range control module
Outdated module software
Internal fault in the transmission control unit
What to do
How to read code P07F2
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P07F2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (F2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07F2 mean?
Transmission range control module communication circuit. The control unit has lost, or is not correctly receiving, communication with the module that controls gearbox range selection. This module is mainly found on cars with an electronic selector. Without reliable communication, the gearbox may not carry out the driver's commands.
Can I keep driving with code P07F2 active?
With caution: limp mode possible, have it checked soon
Common causes — P07F2
Weak battery or unstable supply voltage Damaged wiring or connectors in the data network Faulty or corroded ground connection Faulty range control module Outdated module software Internal fault in the transmission control unit
How do you fix code P07F2?
First check the battery and the ground connections, because low voltage can cause communication errors. If the car does not engage or does not move, have a full diagnosis of the data network carried out.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07F1 — Input/turbine shaft speed sensor C circuit
- Next code: P07F3 — Range selector module communication circuit low
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible