P07F5 — Range selector module supply voltage low
| Meaning | The module that handles gear selection is receiving a supply voltage below the minimum it needs. With low voltage the module can work badly or shut down, and the gearbox may not get the right commands. |
| Family | Powertrain (P) |
Typical symptoms
Gear selector intermittent or stuck
Gearbox not engaging a gear
Other warning lights on at the same time due to low voltage
Slow or difficult starting
Common causes
Dirty or loose battery terminals
Alternator not charging enough
Faulty fuse or relay feeding the module
Poor power or ground wire to the module
Internal fault in the module
What to do
How to read code P07F5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07F5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (F5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07F5 mean?
Range selector module supply voltage low. The module that handles gear selection is receiving a supply voltage below the minimum it needs. With low voltage the module can work badly or shut down, and the gearbox may not get the right commands.
Can I keep driving with code P07F5 active?
With caution: limp mode possible, have it checked soon
Common causes — P07F5
Flat or worn-out battery Dirty or loose battery terminals Alternator not charging enough Faulty fuse or relay feeding the module Poor power or ground wire to the module Internal fault in the module
How do you fix code P07F5?
Check the battery and terminals right away and have the alternator output measured, as this is the most common cause. If the selector misbehaves, do not ignore the warning light, because low voltage can leave you stranded.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07F4 — Range selector module communication circuit high
- Next code: P07F6 — Gear 9 incorrect ratio
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible