P07F4 — Range selector module communication circuit high
| Meaning | The control unit has detected that the communication signal to the transmission range control module is sitting at a higher voltage than normal. Communication between the selector and the gearbox may therefore be wrong or interrupted. The details of this link depend on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Gear selector not responding correctly
Gearbox staying in neutral or not engaging a gear
Gearbox-related warning messages on the dashboard
Hard or impossible starting
Common causes
Damaged connector or bent terminals
Pinched or damaged wiring
Internal fault in the range control module
Problem on the communication network between control units
What to do
How to read code P07F4
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P07F4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (F4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07F4 mean?
Range selector module communication circuit high. The control unit has detected that the communication signal to the transmission range control module is sitting at a higher voltage than normal. Communication between the selector and the gearbox may therefore be wrong or interrupted. The details of this link depend on the manufacturer.
Can I keep driving with code P07F4 active?
With caution: limp mode possible, have it checked soon
Common causes — P07F4
Communication wire touching a power supply line Damaged connector or bent terminals Pinched or damaged wiring Internal fault in the range control module Problem on the communication network between control units
How do you fix code P07F4?
Have the wiring and connectors of the range control module checked, looking for pinching, moisture or bent terminals. If the gearbox does not respond to your commands, do not drive the car and see a workshop soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07F3 — Range selector module communication circuit low
- Next code: P07F5 — Range selector module supply voltage low
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible