P099B — Shift solenoid G control circuit voltage too low
| Meaning | The transmission control unit detected a lower voltage than expected on the control circuit of shift solenoid G. This usually means a short to ground in the wiring, a break, or a failed solenoid. Which gear solenoid G controls depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Gearbox stuck in one gear
Check engine or transmission warning light on
Delay when engaging gears
Gearbox limp mode
Common causes
Corroded connector, or one wet with oil
Solenoid G with a shorted winding
Contaminated gearbox fluid
Fault in the transmission control unit (rare)
What to do
How to read code P099B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P099B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (9) points to transmission, and the last two (9B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P099B mean?
Shift solenoid G control circuit voltage too low. The transmission control unit detected a lower voltage than expected on the control circuit of shift solenoid G. This usually means a short to ground in the wiring, a break, or a failed solenoid. Which gear solenoid G controls depends on the manufacturer.
Can I keep driving with code P099B active?
With caution: limp mode possible, have it checked soon
Common causes — P099B
Gearbox wiring with damaged insulation touching ground Corroded connector, or one wet with oil Solenoid G with a shorted winding Contaminated gearbox fluid Fault in the transmission control unit (rare)
How do you fix code P099B?
Have the gearbox connector and wiring checked first, then the resistance of solenoid G. Check the fluid as well. If the gearbox is in limp mode, limit the use of the car.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P099A — Shift solenoid G performance outside expected rang...
- Next code: P099C — Shift solenoid G control circuit voltage too high
Related codes
- P0900 — Clutch actuator circuit open or faulty
- P0901 — Clutch actuator circuit range/performance
- P0902 — Clutch actuator circuit low
- P0903 — Clutch actuator circuit high
- P0904 — Gate select position sensor circuit (left/right)
- P0905 — Gate select position sensor range/performance
- P0906 — Gate select position sensor circuit low
- P0907 — Gate select position sensor circuit high
- P0908 — Gate select position sensor circuit intermittent
- P0909 — Gate select control error
- P090A — Clutch B actuator control circuit open or faulty
- P090B — Clutch B actuator control circuit performance