P099C — Shift solenoid G control circuit voltage too high
| Meaning | The transmission control unit detected a voltage on the control circuit of shift solenoid "G" that is higher than expected. Which valve the letter G refers to is decided by the manufacturer, so you need the wiring diagram for your car to identify it. The transmission may be unable to command that valve properly. |
| Family | Powertrain (P) |
Typical symptoms
Harsh, delayed or jerky shifts
Transmission stuck in one gear (limp mode)
Gear that will not engage or an unrequested downshift
Worse fuel consumption because of the wrong gears
Common causes
Control wire broken or with abnormal resistance
Solenoid with a faulty coil
Damaged wiring inside the transmission
Faulty transmission control unit (rare)
What to do
How to read code P099C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P099C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (9) points to transmission, and the last two (9C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P099C mean?
Shift solenoid G control circuit voltage too high. The transmission control unit detected a voltage on the control circuit of shift solenoid "G" that is higher than expected. Which valve the letter G refers to is decided by the manufacturer, so you need the wiring diagram for your car to identify it. The transmission may be unable to command that valve properly.
Can I keep driving with code P099C active?
With caution: limp mode possible, have it checked soon
Common causes — P099C
Corroded or poorly seated connector or wiring at the transmission Control wire broken or with abnormal resistance Solenoid with a faulty coil Damaged wiring inside the transmission Faulty transmission control unit (rare)
How do you fix code P099C?
Have the code read with a tool that shows transmission data, and check the connector and wiring to the valve first. If the transmission has gone into limp mode, avoid long trips and heavy loads, because other parts can be damaged.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P099B — Shift solenoid G control circuit voltage too low
- Next code: P099D — Shift solenoid H control circuit performance probl...
Related codes
- P0900 — Clutch actuator circuit open or faulty
- P0901 — Clutch actuator circuit range/performance
- P0902 — Clutch actuator circuit low
- P0903 — Clutch actuator circuit high
- P0904 — Gate select position sensor circuit (left/right)
- P0905 — Gate select position sensor range/performance
- P0906 — Gate select position sensor circuit low
- P0907 — Gate select position sensor circuit high
- P0908 — Gate select position sensor circuit intermittent
- P0909 — Gate select control error
- P090A — Clutch B actuator control circuit open or faulty
- P090B — Clutch B actuator control circuit performance