Skip to content
Fault code dictionary (DTC)

P0A28 — Hybrid battery disconnect circuit voltage low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees a lower than expected voltage in the circuit that disconnects the high-voltage battery. It may point to a broken wire, a short to ground or a component that does not respond. This circuit concerns high-voltage safety.
FamilyPowertrain (P)

Typical symptoms

Hybrid or electric system warning light on
Car will not go into ready mode
System shuts down suddenly
Charging not possible
High-voltage check messages

Common causes

Command circuit wire broken or shorted to ground
Corroded or disconnected connector
Faulty relay or contactor
Unstable 12 V supply
Battery control unit fault

What to do

Do not touch orange cables or the high-voltage battery: qualified staff are needed. Have the wiring, connectors and relays checked with a scan tool. If the car shuts down or will not start, do not keep trying.

How to read code P0A28

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0A28 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (28) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0A28 mean?

Hybrid battery disconnect circuit voltage low. The control unit sees a lower than expected voltage in the circuit that disconnects the high-voltage battery. It may point to a broken wire, a short to ground or a component that does not respond. This circuit concerns high-voltage safety.

Can I keep driving with code P0A28 active?

With caution: limp mode possible, have it checked soon

Common causes — P0A28

Command circuit wire broken or shorted to ground Corroded or disconnected connector Faulty relay or contactor Unstable 12 V supply Battery control unit fault

How do you fix code P0A28?

Do not touch orange cables or the high-voltage battery: qualified staff are needed. Have the wiring, connectors and relays checked with a scan tool. If the car shuts down or will not start, do not keep trying.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes