P0A41 — Drive motor A position sensor: signal too low
| Meaning | The control unit measured a voltage that is too low on the motor A position sensor circuit. This usually points to a short to ground in the wiring or a failed resolver. The control unit no longer knows where the rotor is. |
| Family | Powertrain (P) |
Typical symptoms
Vehicle that won't start or stops
Sudden loss of power
Jerking when accelerating
Limp mode
Common causes
Shorted position sensor (resolver)
Damaged or wet connector
Chafed or crushed wiring
Internal control unit or inverter fault
What to do
How to read code P0A41
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0A41 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (41) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0A41 mean?
Drive motor A position sensor: signal too low. The control unit measured a voltage that is too low on the motor A position sensor circuit. This usually points to a short to ground in the wiring or a failed resolver. The control unit no longer knows where the rotor is.
Can I keep driving with code P0A41 active?
With caution: limp mode possible, have it checked soon
Common causes — P0A41
Sensor wire touching ground Shorted position sensor (resolver) Damaged or wet connector Chafed or crushed wiring Internal control unit or inverter fault
How do you fix code P0A41?
Have the vehicle checked soon at a workshop qualified for high voltage, starting with the sensor wiring and connectors. If power drops suddenly, pull over safely.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0A40 — Drive motor A position sensor: implausible signal
- Next code: P0A42 — Drive motor A position sensor signal too high
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem