Skip to content
Fault code dictionary (DTC)

P0A42 — Drive motor A position sensor signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe hybrid or electric system control unit has detected that the electrical signal from drive motor A's position sensor stays above the allowed value. This sensor tells the controller where the rotor is, which is essential for driving the motor accurately. Without a believable signal, the system may limit power as a safety measure.
FamilyPowertrain (P)

Typical symptoms

Check engine or hybrid system warning light on
Reduced power or limp mode
Jerky driving or vibration under acceleration
Car will not start or will not go into ready mode
Combustion engine running more than usual (on hybrids)

Common causes

Corroded or poorly seated sensor connector
Damaged wiring between motor and inverter, or a short to supply voltage
Faulty position sensor (resolver)
Internal fault in the inverter control unit
Interference from a damaged shielded cable

What to do

Have the car checked by a shop qualified for high-voltage systems, and do not touch the orange cables yourself. The first step is a visual check of the sensor connector and wiring, followed by reading live data. Do not leave it too long, as the car can stop without warning.

How to read code P0A42

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0A42 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (42) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0A42 mean?

Drive motor A position sensor signal too high. The hybrid or electric system control unit has detected that the electrical signal from drive motor A's position sensor stays above the allowed value. This sensor tells the controller where the rotor is, which is essential for driving the motor accurately. Without a believable signal, the system may limit power as a safety measure.

Can I keep driving with code P0A42 active?

With caution: limp mode possible, have it checked soon

Common causes — P0A42

Corroded or poorly seated sensor connector Damaged wiring between motor and inverter, or a short to supply voltage Faulty position sensor (resolver) Internal fault in the inverter control unit Interference from a damaged shielded cable

How do you fix code P0A42?

Have the car checked by a shop qualified for high-voltage systems, and do not touch the orange cables yourself. The first step is a visual check of the sensor connector and wiring, followed by reading live data. Do not leave it too long, as the car can stop without warning.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes