P0AB6 — Active engine mount B control circuit open
| Meaning | The control unit has found that the circuit driving engine mount B, an electronically controlled mount that dampens engine vibration, is broken or not responding. Which mount is B depends on the manufacturer. This fault generally affects comfort rather than driving safety. |
| Family | Powertrain (P) |
Typical symptoms
Shaking at idle or when the engine stops
More noise with the engine running
Engine or hybrid system warning light on
Sharp shudder when the combustion engine starts or stops
Common causes
Broken control wire
Faulty mount solenoid or actuator
Driver fault inside the control unit
Wiring damaged by heat or chafing
What to do
How to read code P0AB6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0AB6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (B6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0AB6 mean?
Active engine mount B control circuit open. The control unit has found that the circuit driving engine mount B, an electronically controlled mount that dampens engine vibration, is broken or not responding. Which mount is B depends on the manufacturer. This fault generally affects comfort rather than driving safety.
Can I keep driving with code P0AB6 active?
With caution: limp mode possible, have it checked soon
Common causes — P0AB6
Mount connector unplugged or oxidised Broken control wire Faulty mount solenoid or actuator Driver fault inside the control unit Wiring damaged by heat or chafing
How do you fix code P0AB6?
First check the mount connector and wiring, then the actuator. You can usually keep driving, but the vibration stresses other parts, so have it looked at within a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0AB5 — Battery air temperature sensor B signal intermitte...
- Next code: P0AB7 — Active engine mount B control circuit low
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem