P0AB7 — Active engine mount B control circuit low
| Meaning | The control unit sees too low a voltage on the control circuit of engine mount B, typical of a short to ground. Which mount is B depends on the manufacturer. The mount may no longer damp vibration well. |
| Family | Powertrain (P) |
Typical symptoms
Shaking at idle
More noise with the engine running
Engine or hybrid system warning light on
Jolt when the combustion engine starts or stops
Common causes
Mount solenoid or actuator shorted internally
Wet or corroded connector
Wiring pinched or burnt near the engine
Driver fault inside the control unit
What to do
How to read code P0AB7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0AB7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (B7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0AB7 mean?
Active engine mount B control circuit low. The control unit sees too low a voltage on the control circuit of engine mount B, typical of a short to ground. Which mount is B depends on the manufacturer. The mount may no longer damp vibration well.
Can I keep driving with code P0AB7 active?
With caution: limp mode possible, have it checked soon
Common causes — P0AB7
Control wire shorted to ground Mount solenoid or actuator shorted internally Wet or corroded connector Wiring pinched or burnt near the engine Driver fault inside the control unit
How do you fix code P0AB7?
Have the wiring and mount actuator checked to look for a short. A prolonged short can also damage the control unit, so do not leave it too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0AB6 — Active engine mount B control circuit open
- Next code: P0AB8 — Active engine mount B control circuit high
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem