P0ACC — Hybrid/EV battery temperature sensor C: signal too low
| Meaning | On the circuit of battery pack temperature sensor C, the control unit is reading a signal lower than the minimum allowed. With this type of sensor, a low signal is often read as a very high temperature, but the cause may be a short to ground, a faulty sensor or defective wiring. The system no longer knows the true temperature and may limit operation. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Battery cooling fan running at full speed
Limited or interrupted charging
Hybrid/EV system fault message
Common causes
Faulty temperature sensor
Damaged connector or moisture in it
Fault in the battery management control unit
Battery temperature genuinely very high
What to do
How to read code P0ACC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0ACC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (CC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0ACC mean?
Hybrid/EV battery temperature sensor C: signal too low. On the circuit of battery pack temperature sensor C, the control unit is reading a signal lower than the minimum allowed. With this type of sensor, a low signal is often read as a very high temperature, but the cause may be a short to ground, a faulty sensor or defective wiring. The system no longer knows the true temperature and may limit operation.
Can I keep driving with code P0ACC active?
With caution: limp mode possible, have it checked soon
Common causes — P0ACC
Sensor wire shorted to ground Faulty temperature sensor Damaged connector or moisture in it Fault in the battery management control unit Battery temperature genuinely very high
How do you fix code P0ACC?
Do not touch the battery pack or the orange cables: a certified shop is needed. First check whether the battery is really hot, then the sensor, wiring and connectors. If you notice strange smells or the battery is very hot, stop safely and do not charge.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0ACB — Hybrid/EV battery temperature sensor C: signal out...
- Next code: P0ACD — Hybrid/EV battery temperature sensor C: signal too...
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem