P0AE6 — Precharge contactor control circuit low
| Meaning | The control unit has detected too low a voltage on the control circuit of precharge contactor A. This usually points to a control wire shorted to ground or a fault in the driver that operates it. The contactor may not be energised and the system may not enable high voltage. |
| Family | Powertrain (P) |
Typical symptoms
Vehicle will not enter Ready mode
Warning message on the instrument cluster
No electric drive or reduced power
Blown control fuse
Common causes
Shorted contactor coil
Pinched wiring or damaged insulation
Driver fault in the battery management unit
Water ingress in connectors
What to do
How to read code P0AE6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0AE6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (E6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0AE6 mean?
Precharge contactor control circuit low. The control unit has detected too low a voltage on the control circuit of precharge contactor A. This usually points to a control wire shorted to ground or a fault in the driver that operates it. The contactor may not be energised and the system may not enable high voltage.
Can I keep driving with code P0AE6 active?
With caution: limp mode possible, have it checked soon
Common causes — P0AE6
Control wire shorted to ground Shorted contactor coil Pinched wiring or damaged insulation Driver fault in the battery management unit Water ingress in connectors
How do you fix code P0AE6?
Have the circuit checked by staff qualified for high voltage. Avoid restarting the car repeatedly if it will not start, as a short can damage other components.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0AE5 — Precharge contactor control circuit performance
- Next code: P0AE7 — Precharge contactor control circuit high
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem