Skip to content
Fault code dictionary (DTC)

P0AE7 — Precharge contactor control circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has detected too high a voltage on the control circuit of precharge contactor A. This usually points to a short to supply voltage or a fault in the control unit driver. The contactor command is not reliable and the system may block high-voltage activation.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Vehicle will not start or enter Ready
Warning message on the instrument cluster
Reduced power
Contactor operating erratically

Common causes

Control wire shorted to supply voltage
Driver fault in the battery management unit
Damaged wiring touching another wire
Damaged or damp connectors
Faulty contactor coil

What to do

Have the wiring and control unit checked at a workshop qualified for high-voltage vehicles. This is not a check to do yourself. If the car is in limp mode, use it only to reach the workshop.

How to read code P0AE7

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0AE7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (E7) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0AE7 mean?

Precharge contactor control circuit high. The control unit has detected too high a voltage on the control circuit of precharge contactor A. This usually points to a short to supply voltage or a fault in the control unit driver. The contactor command is not reliable and the system may block high-voltage activation.

Can I keep driving with code P0AE7 active?

With caution: limp mode possible, have it checked soon

Common causes — P0AE7

Control wire shorted to supply voltage Driver fault in the battery management unit Damaged wiring touching another wire Damaged or damp connectors Faulty contactor coil

How do you fix code P0AE7?

Have the wiring and control unit checked at a workshop qualified for high-voltage vehicles. This is not a check to do yourself. If the car is in limp mode, use it only to reach the workshop.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes