P0AF6 — Drive motor inverter temp sensor B: erratic signal
| Meaning | The hybrid control unit detected that the signal from temperature sensor B on the drive motor inverter is jumping or inconsistent from time to time. The inverter is the module that converts battery power to run the electric motor. If its temperature can't be read reliably, the system can't protect it from overheating. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Inverter cooling fans or pump behaving oddly
Fault appears and disappears with no clear pattern
Service messages on the dashboard
Common causes
Chafed wiring or an intermittent contact in the sensor harness
Faulty temperature sensor
Internal problem in the inverter module
Moisture in the connector
What to do
How to read code P0AF6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0AF6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (F6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0AF6 mean?
Drive motor inverter temp sensor B: erratic signal. The hybrid control unit detected that the signal from temperature sensor B on the drive motor inverter is jumping or inconsistent from time to time. The inverter is the module that converts battery power to run the electric motor. If its temperature can't be read reliably, the system can't protect it from overheating.
Can I keep driving with code P0AF6 active?
With caution: limp mode possible, have it checked soon
Common causes — P0AF6
Corroded or poorly seated sensor connector Chafed wiring or an intermittent contact in the sensor harness Faulty temperature sensor Internal problem in the inverter module Moisture in the connector
How do you fix code P0AF6?
Have the sensor connection and harness checked first, since intermittent contacts are the most common cause. High-voltage parts of hybrid and electric cars should only be handled by qualified staff. Don't leave it too long: an inverter that isn't properly protected from heat can be damaged.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0AF5 — Inverter temperature sensor B circuit high
- Next code: P0AF7 — 14 V power module (DC/DC converter): internal temp...
Related codes
- P0A00 — Motor electronics coolant temperature sensor circuit fault
- P0A01 — Motor electronics coolant temperature sensor implausible
- P0A02 — Motor electronics coolant temperature sensor signal too low
- P0A03 — Motor electronics coolant temperature sensor signal too high
- P0A04 — Motor electronics coolant temperature sensor intermittent
- P0A05 — Motor electronics coolant pump control circuit open
- P0A06 — Motor electronics coolant pump control circuit low
- P0A07 — Motor electronics coolant pump control circuit high
- P0A08 — DC/DC converter status circuit fault
- P0A09 — DC/DC converter status signal too low
- P0A0A — High voltage system interlock circuit A fault
- P0A0B — High voltage interlock circuit A performance problem