Skip to content
Fault code dictionary (DTC)

P0E38 — DC/DC converter voltage sensor B: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads a lower-than-normal signal from DC/DC converter voltage sensor B. It may come from a short to ground or from a truly low voltage. Management of the 12 V battery suffers.
FamilyPowertrain (P)

Typical symptoms

Battery or hybrid system warning light on
Flat 12 V battery
Dim lights
Uncertain system start-up

Common causes

Sensor wiring shorted to ground
Faulty sensor
DC/DC converter delivering too little
Weak 12 V battery
Connector with water or corrosion

What to do

Start with the 12 V battery and its terminals. If the problem remains, a qualified shop is needed to measure the circuit and converter. With low voltage the car can shut down suddenly.

How to read code P0E38

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0E38 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0E38 mean?

DC/DC converter voltage sensor B: signal too low. The control unit reads a lower-than-normal signal from DC/DC converter voltage sensor B. It may come from a short to ground or from a truly low voltage. Management of the 12 V battery suffers.

Can I keep driving with code P0E38 active?

With caution: limp mode possible, have it checked soon

Common causes — P0E38

Sensor wiring shorted to ground Faulty sensor DC/DC converter delivering too little Weak 12 V battery Connector with water or corrosion

How do you fix code P0E38?

Start with the 12 V battery and its terminals. If the problem remains, a qualified shop is needed to measure the circuit and converter. With low voltage the car can shut down suddenly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes