P0E3E — Control Pilot indicator circuit: signal too high
| Meaning | The control unit detected too high a voltage in the circuit that drives the Control Pilot indicator. The Control Pilot is the signal the car and the charging station use to exchange information during charging. The circuit is sitting at a higher voltage than expected. The exact name and location of the indicator vary by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Malfunction or hybrid/electric system warning light on
Charge indicator light at the charging port is off or behaves oddly
Charging error message on the display
Charging works with some stations but not others
Common causes
Charging port connector damaged, dirty or wet
Failure of the indicator component in the charging port
Internal fault in the charging control module
Loose module connector or corroded terminals
What to do
How to read code P0E3E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E3E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E3E mean?
Control Pilot indicator circuit: signal too high. The control unit detected too high a voltage in the circuit that drives the Control Pilot indicator. The Control Pilot is the signal the car and the charging station use to exchange information during charging. The circuit is sitting at a higher voltage than expected. The exact name and location of the indicator vary by manufacturer.
Can I keep driving with code P0E3E active?
With caution: limp mode possible, have it checked soon
Common causes — P0E3E
Indicator circuit wiring touching a power supply wire Charging port connector damaged, dirty or wet Failure of the indicator component in the charging port Internal fault in the charging control module Loose module connector or corroded terminals
How do you fix code P0E3E?
First check the charging port for dirt, moisture, burn marks or bent pins, and try another station or cable. If the code stays, have the wiring and connectors checked with a diagnostic tool. You can drive the car, but do not keep retrying charging if you notice heat or a strange smell at the port.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E3D — Control pilot indicator control circuit low
- Next code: P0E3F — Charge status indicator A: circuit signal low
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high