P0E3F — Charge status indicator A: circuit signal low
| Meaning | The control unit detected too low a voltage in the control circuit of charge status indicator A, which is the light or signal that shows how charging is going. The letter A tells it apart from a similar indicator, but its exact location depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Hard to tell from the lights whether the car is charging
Malfunction warning light on
Charging does not start or stops
Charging-related error message
Common causes
Charging port connector dirty, corroded or wet
Failed indicator or LED in the port
Faulty charging control module
Loose module connector
What to do
How to read code P0E3F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E3F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E3F mean?
Charge status indicator A: circuit signal low. The control unit detected too low a voltage in the control circuit of charge status indicator A, which is the light or signal that shows how charging is going. The letter A tells it apart from a similar indicator, but its exact location depends on the manufacturer.
Can I keep driving with code P0E3F active?
With caution: limp mode possible, have it checked soon
Common causes — P0E3F
Indicator circuit wire shorted to ground or damaged Charging port connector dirty, corroded or wet Failed indicator or LED in the port Faulty charging control module Loose module connector
How do you fix code P0E3F?
Look at the charging port and its connectors for moisture, dirt or visible damage. Then have the data read with a diagnostic tool and the wiring checked. It usually does not stop the car, but charging may be affected, so do not put it off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E3E — Control Pilot indicator circuit: signal too high
- Next code: P0E40 — Charge status indicator A: circuit signal high
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high