P0E40 — Charge status indicator A: circuit signal high
| Meaning | The control unit detected too high a voltage in the control circuit of charge status indicator A, the signal that shows how charging is going. The voltage is above the expected value. The exact meaning of the letter A depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Malfunction warning light on
Charging does not start or is interrupted
Charging error message
Charging signals that do not match the real state
Common causes
Charging port connector damaged or wet
Failed indicator in the port
Faulty charging control module
Corroded or loose connector terminals
What to do
How to read code P0E40
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E40 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E40 mean?
Charge status indicator A: circuit signal high. The control unit detected too high a voltage in the control circuit of charge status indicator A, the signal that shows how charging is going. The voltage is above the expected value. The exact meaning of the letter A depends on the manufacturer.
Can I keep driving with code P0E40 active?
With caution: limp mode possible, have it checked soon
Common causes — P0E40
Indicator wiring touching a power supply wire Charging port connector damaged or wet Failed indicator in the port Faulty charging control module Corroded or loose connector terminals
How do you fix code P0E40?
Check the charging port for dirt, moisture and signs of overheating. If the code returns, have the wiring and connectors checked with a diagnostic tool. If you notice heat or a burning smell at the port, stop charging and have it checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E3F — Charge status indicator A: circuit signal low
- Next code: P0E41 — Charge status indicator B: circuit signal low
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high