Skip to content
Fault code dictionary (DTC)

P0E42 — Charge status indicator B: circuit signal high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected too high a voltage in the control circuit of charge status indicator B, a second indicator of charging progress. The voltage is above the expected value. The exact meaning of the letter B depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Charge indicator always on or abnormal
Malfunction warning light on
Charging does not start or is interrupted
Charging error message
Signals that do not match the real state

Common causes

Wiring touching a power supply wire
Charging port connector damaged or wet
Failed indicator in the port
Faulty charging control module
Corroded or loose terminals

What to do

Check the charging port for dirt, moisture and signs of overheating. If the code returns, have the wiring and connectors checked with a diagnostic tool. With heat or a burning smell at the port, stop charging and have it checked right away.

How to read code P0E42

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0E42 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0E42 mean?

Charge status indicator B: circuit signal high. The control unit detected too high a voltage in the control circuit of charge status indicator B, a second indicator of charging progress. The voltage is above the expected value. The exact meaning of the letter B depends on the manufacturer.

Can I keep driving with code P0E42 active?

With caution: limp mode possible, have it checked soon

Common causes — P0E42

Wiring touching a power supply wire Charging port connector damaged or wet Failed indicator in the port Faulty charging control module Corroded or loose terminals

How do you fix code P0E42?

Check the charging port for dirt, moisture and signs of overheating. If the code returns, have the wiring and connectors checked with a diagnostic tool. With heat or a burning smell at the port, stop charging and have it checked right away.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes