P0E89 — Battery charger B input current too high
| Meaning | The control unit detected that charger B draws more current than the allowed limit. To avoid damage, charging is reduced or stopped. The problem may be in the charger, the wiring or the current measurement. Which unit is B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Charging suddenly interrupted
Trip switch or breaker tripping
Charging error message
Cable or socket hotter than normal
Common causes
Short circuit in the charging wiring
Damaged cable or socket
Current sensor reading a wrong value
Charging post or installation supplying more than expected
What to do
How to read code P0E89
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E89 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E89 mean?
Battery charger B input current too high. The control unit detected that charger B draws more current than the allowed limit. To avoid damage, charging is reduced or stopped. The problem may be in the charger, the wiring or the current measurement. Which unit is B depends on the manufacturer.
Can I keep driving with code P0E89 active?
With caution: limp mode possible, have it checked soon
Common causes — P0E89
Internal charger fault Short circuit in the charging wiring Damaged cable or socket Current sensor reading a wrong value Charging post or installation supplying more than expected
How do you fix code P0E89?
Stop charging if you notice a very hot cable, socket or connector, or signs of burning, and do not try again. Then try another charging post and cable. If the code returns, have the car checked at a workshop before charging again.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E88 — Battery charger B input current too low
- Next code: P0E8A — Battery charger B input current sensor circuit
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high