P0E88 — Battery charger B input current too low
| Meaning | The control unit detected that charger B draws less current than expected. Charging may therefore be slower or not progress. The cause may be in the mains, the cable, the charging point or the car. Which unit is B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Very slow charging
Charging stops
Charging error message
Charging time longer than usual
Common causes
Faulty charging cable
Dirty or worn contacts in the car's inlet
Charger limiting current for protection
Wrong current sensor
Internal charger fault
What to do
How to read code P0E88
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0E88 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0E88 mean?
Battery charger B input current too low. The control unit detected that charger B draws less current than expected. Charging may therefore be slower or not progress. The cause may be in the mains, the cable, the charging point or the car. Which unit is B depends on the manufacturer.
Can I keep driving with code P0E88 active?
With caution: limp mode possible, have it checked soon
Common causes — P0E88
Charging post or wallbox limiting power Faulty charging cable Dirty or worn contacts in the car's inlet Charger limiting current for protection Wrong current sensor Internal charger fault
How do you fix code P0E88?
Try charging with another charging post and cable and check that the contacts are clean. If the problem remains everywhere, have the charger data read at a workshop. It is usually not a fault that stops you using the car, but it limits charging.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0E87 — Battery charger B input voltage too high
- Next code: P0E89 — Battery charger B input current too high
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high