Skip to content
Fault code dictionary (DTC)

P0E94 — Drive motor B inverter: voltage sensor B signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit read a signal that is too high from voltage sensor B on the inverter for motor B. It can point to an open circuit, a short to supply, or a faulty sensor. The meaning of 'B' depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV warning light on
Limited power
Fault message
Second motor's drive limited
Uneven system start-up

Common causes

Wire open or shorted to supply
Damaged connector
Faulty voltage sensor
Internal inverter fault
Control unit problem

What to do

This is a high-voltage circuit: it needs qualified staff and the components shouldn't be opened. Have the wiring and sensor checked at a workshop. With reduced power, drive carefully.

How to read code P0E94

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0E94 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0E94 mean?

Drive motor B inverter: voltage sensor B signal too high. The control unit read a signal that is too high from voltage sensor B on the inverter for motor B. It can point to an open circuit, a short to supply, or a faulty sensor. The meaning of 'B' depends on the manufacturer.

Can I keep driving with code P0E94 active?

With caution: limp mode possible, have it checked soon

Common causes — P0E94

Wire open or shorted to supply Damaged connector Faulty voltage sensor Internal inverter fault Control unit problem

How do you fix code P0E94?

This is a high-voltage circuit: it needs qualified staff and the components shouldn't be opened. Have the wiring and sensor checked at a workshop. With reduced power, drive carefully.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes