P0EAB — A/C compressor motor voltage sensor B: signal too low
| Meaning | The control unit found that the signal from voltage sensor "B" on the A/C compressor motor is below the expected minimum. It can be caused by a broken wire or a short to ground, a faulty sensor or a missing supply. The system may switch the compressor off to protect it. |
| Family | Powertrain (P) |
Typical symptoms
Warning light on
Compressor not starting
Warning messages on the dashboard
Cabin not cooling down
Common causes
Signal wire shorted to ground
Corroded or loose connector
Faulty voltage sensor
Fault in the compressor inverter
Missing high-voltage supply to the compressor
What to do
How to read code P0EAB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EAB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EAB mean?
A/C compressor motor voltage sensor B: signal too low. The control unit found that the signal from voltage sensor "B" on the A/C compressor motor is below the expected minimum. It can be caused by a broken wire or a short to ground, a faulty sensor or a missing supply. The system may switch the compressor off to protect it.
Can I keep driving with code P0EAB active?
With caution: limp mode possible, have it checked soon
Common causes — P0EAB
Broken sensor wire or poor contact Signal wire shorted to ground Corroded or loose connector Faulty voltage sensor Fault in the compressor inverter Missing high-voltage supply to the compressor
How do you fix code P0EAB?
Have the wiring, connectors and compressor supply checked, then the sensor values with a diagnostic tool. Only qualified personnel should work on high voltage. You can drive, but the air conditioning may stay out of use.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EAA — A/C compressor motor voltage sensor B: signal too...
- Next code: P0EAC — A/C compressor motor voltage sensor B: erratic sig...
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high