P0EB3 — A/C compressor motor phase U current sensor: signal too low
| Meaning | The control unit found that the signal from the phase U current sensor on the A/C compressor motor is below the expected minimum. It can be a broken wire, a short to ground, a faulty sensor or a motor phase that isn't conducting. The compressor may be switched off to protect it. |
| Family | Powertrain (P) |
Typical symptoms
Warning light on
Compressor not starting or running roughly
Warning messages on the dashboard
Cabin not cooling down
Common causes
Signal wire shorted to ground
Corroded or loose connector
Faulty phase U current sensor
Fault in the compressor inverter
Broken phase U connection to the motor
What to do
How to read code P0EB3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EB3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EB3 mean?
A/C compressor motor phase U current sensor: signal too low. The control unit found that the signal from the phase U current sensor on the A/C compressor motor is below the expected minimum. It can be a broken wire, a short to ground, a faulty sensor or a motor phase that isn't conducting. The compressor may be switched off to protect it.
Can I keep driving with code P0EB3 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EB3
Broken sensor wire or poor contact Signal wire shorted to ground Corroded or loose connector Faulty phase U current sensor Fault in the compressor inverter Broken phase U connection to the motor
How do you fix code P0EB3?
Have the wiring, connectors and the inverter-to-compressor connection checked, then the values with a diagnostic tool. Only qualified personnel should work on high voltage. You can drive, but the air conditioning may stay off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EB2 — A/C compressor motor phase U current sensor: signa...
- Next code: P0EB4 — A/C compressor motor phase U current sensor: range...
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high