Skip to content
Fault code dictionary (DTC)

P0EB2 — A/C compressor motor phase U current sensor: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found that the signal from the phase U current sensor on the A/C compressor motor is above the expected maximum. It can come from a fault in the measuring circuit, a faulty sensor or a genuinely excessive draw on that phase. The compressor may be stopped to protect it.
FamilyPowertrain (P)

Typical symptoms

Air conditioning not cooling or cutting out
Warning light on
Compressor not running
Warning messages on the dashboard
Unusual noises or smells from the compressor

Common causes

Signal wire shorted to the supply voltage
Faulty phase U current sensor
Compressor motor with degraded winding or insulation
Faulty compressor inverter
Damaged or damp connector

What to do

Have the wiring, connectors and phase U values checked with a diagnostic tool. If you smell burning or hear loud noises from the compressor, avoid using the air conditioning. High voltage is for qualified personnel only.

How to read code P0EB2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0EB2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0EB2 mean?

A/C compressor motor phase U current sensor: signal too high. The control unit found that the signal from the phase U current sensor on the A/C compressor motor is above the expected maximum. It can come from a fault in the measuring circuit, a faulty sensor or a genuinely excessive draw on that phase. The compressor may be stopped to protect it.

Can I keep driving with code P0EB2 active?

With caution: limp mode possible, have it checked soon

Common causes — P0EB2

Signal wire shorted to the supply voltage Faulty phase U current sensor Compressor motor with degraded winding or insulation Faulty compressor inverter Damaged or damp connector

How do you fix code P0EB2?

Have the wiring, connectors and phase U values checked with a diagnostic tool. If you smell burning or hear loud noises from the compressor, avoid using the air conditioning. High voltage is for qualified personnel only.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes