Skip to content
Fault code dictionary (DTC)

P0ED2 — HV battery F voltage: too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detects that the voltage of the battery labelled F is below the expected minimum. The letter identifies a pack or section, as set by the manufacturer. It may be a genuine discharge or cell wear, or a wrong reading caused by a faulty sensor or connection.
FamilyPowertrain (P)

Typical symptoms

Warning light or hybrid system light on
Much reduced electric range
Limited power when accelerating
Hybrid system not starting or shutting down
Charging ending too early or not starting

Common causes

Battery discharged after long inactivity
Worn or unbalanced cells
Cable or connection with high resistance
Voltage sensor reading too low
Insulation loss or internal pack fault

What to do

Have the real voltage of section F checked with a suitable tool, to see whether the fault is real or just a measuring one. Do not touch the orange cables or open the pack: qualified staff are needed. With power loss or failure to start, do not keep trying repeatedly.

How to read code P0ED2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0ED2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0ED2 mean?

HV battery F voltage: too low. The control unit detects that the voltage of the battery labelled F is below the expected minimum. The letter identifies a pack or section, as set by the manufacturer. It may be a genuine discharge or cell wear, or a wrong reading caused by a faulty sensor or connection.

Can I keep driving with code P0ED2 active?

With caution: limp mode possible, have it checked soon

Common causes — P0ED2

Battery discharged after long inactivity Worn or unbalanced cells Cable or connection with high resistance Voltage sensor reading too low Insulation loss or internal pack fault

How do you fix code P0ED2?

Have the real voltage of section F checked with a suitable tool, to see whether the fault is real or just a measuring one. Do not touch the orange cables or open the pack: qualified staff are needed. With power loss or failure to start, do not keep trying repeatedly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes