Skip to content
Fault code dictionary (DTC)

P0ED3 — HV battery F voltage: too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detects that the voltage of the battery labelled F exceeds the expected maximum. The letter identifies a pack or section, as set by the manufacturer. It may be a charging or cell management problem, or a wrong sensor reading. Too high a voltage can damage the cells, so the system protects itself by limiting or stopping charging.
FamilyPowertrain (P)

Typical symptoms

Warning light or hybrid system light on
Reduced or no regenerative braking
Charging stopping
Limited power
Battery fan running more than normal

Common causes

Voltage sensor reading too high
Unbalanced cells, with some being overcharged
Fault in the control module or cell balancing
Problem in the charging system
Faulty connection in the measuring circuit

What to do

Have the real voltage and that of each cell block of section F checked with a suitable tool. Do not touch the orange cables or open the pack: qualified staff are needed. If you notice unusual heat or smells from the battery, stop safely and do not charge.

How to read code P0ED3

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0ED3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0ED3 mean?

HV battery F voltage: too high. The control unit detects that the voltage of the battery labelled F exceeds the expected maximum. The letter identifies a pack or section, as set by the manufacturer. It may be a charging or cell management problem, or a wrong sensor reading. Too high a voltage can damage the cells, so the system protects itself by limiting or stopping charging.

Can I keep driving with code P0ED3 active?

With caution: limp mode possible, have it checked soon

Common causes — P0ED3

Voltage sensor reading too high Unbalanced cells, with some being overcharged Fault in the control module or cell balancing Problem in the charging system Faulty connection in the measuring circuit

How do you fix code P0ED3?

Have the real voltage and that of each cell block of section F checked with a suitable tool. Do not touch the orange cables or open the pack: qualified staff are needed. If you notice unusual heat or smells from the battery, stop safely and do not charge.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes