Skip to content
Fault code dictionary (DTC)

P0ED4 — Generator phase X current: invalid signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe generator (or motor-generator) in the hybrid system is three-phase, and the control unit measures the current of each phase. The phase labelled X gave an incorrect or implausible reading. The code does not say whether the current is too high or too low: it flags a general fault in the measuring circuit or the phase.
FamilyPowertrain (P)

Typical symptoms

Warning light or hybrid system light on
Reduced power or limp mode
Vibration or irregular running of the generator
Poor battery charging
Combustion engine running oddly on a hybrid

Common causes

Faulty phase X current sensor
Damaged or corroded phase X wiring or connector
Inverter or inverter control circuit fault
Faulty generator winding
Moisture or water ingress in the inverter

What to do

Have the data of the three phases read with a suitable tool and compared with each other. Visually check any accessible wiring, without touching the orange high-voltage cables. With power loss do not drive for long, and see qualified staff.

How to read code P0ED4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0ED4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0ED4 mean?

Generator phase X current: invalid signal. The generator (or motor-generator) in the hybrid system is three-phase, and the control unit measures the current of each phase. The phase labelled X gave an incorrect or implausible reading. The code does not say whether the current is too high or too low: it flags a general fault in the measuring circuit or the phase.

Can I keep driving with code P0ED4 active?

With caution: limp mode possible, have it checked soon

Common causes — P0ED4

Faulty phase X current sensor Damaged or corroded phase X wiring or connector Inverter or inverter control circuit fault Faulty generator winding Moisture or water ingress in the inverter

How do you fix code P0ED4?

Have the data of the three phases read with a suitable tool and compared with each other. Visually check any accessible wiring, without touching the orange high-voltage cables. With power loss do not drive for long, and see qualified staff.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes