P0EE3 — A/C refrigerant valve B: control circuit open
| Meaning | The control unit has detected an electrical break in the circuit that commands refrigerant distribution valve B of the air conditioning. In practice the command does not reach the valve, as if a wire had come loose. Which air conditioning circuit valve B serves differs between manufacturers. |
| Family | Powertrain (P) |
Typical symptoms
Cold air not reaching where it should
Reduced cooling of the high-voltage battery
Warning light on
Power limitation on hot days
Common causes
Corroded or loose connector terminals
Valve with an open internal coil
Blown fuse or missing power supply
Faulty thermal management control unit
What to do
How to read code P0EE3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EE3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EE3 mean?
A/C refrigerant valve B: control circuit open. The control unit has detected an electrical break in the circuit that commands refrigerant distribution valve B of the air conditioning. In practice the command does not reach the valve, as if a wire had come loose. Which air conditioning circuit valve B serves differs between manufacturers.
Can I keep driving with code P0EE3 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EE3
Broken wire or disconnected connector Corroded or loose connector terminals Valve with an open internal coil Blown fuse or missing power supply Faulty thermal management control unit
How do you fix code P0EE3?
Have the connector and wiring of valve B checked first, then its power supply and coil resistance. You can keep driving, but in hot weather reduced cooling can put a strain on the battery, so do not put it off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EE2 — A/C refrigerant distribution valve B stuck or open
- Next code: P0EE4 — A/C refrigerant valve B: control circuit low
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high