P0EE4 — A/C refrigerant valve B: control circuit low
| Meaning | The control unit measured a lower voltage than expected in the control circuit of refrigerant distribution valve B. This usually means a wire touching ground or a component drawing too much current. The valve may therefore not move correctly. Which air conditioning circuit valve B controls depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Insufficient battery cooling
Warning light on
Limited power or charging in hot weather
Valve not heard moving at start-up
Common causes
Wet or corroded connector
Valve coil short-circuited
Wiring damaged by rubbing
Faulty control unit driver
What to do
How to read code P0EE4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EE4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EE4 mean?
A/C refrigerant valve B: control circuit low. The control unit measured a lower voltage than expected in the control circuit of refrigerant distribution valve B. This usually means a wire touching ground or a component drawing too much current. The valve may therefore not move correctly. Which air conditioning circuit valve B controls depends on the manufacturer.
Can I keep driving with code P0EE4 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EE4
Control wire in contact with ground Wet or corroded connector Valve coil short-circuited Wiring damaged by rubbing Faulty control unit driver
How do you fix code P0EE4?
Have the wiring and connector of valve B inspected for signs of rubbing or moisture, then the coil and control signal measured. It is not a fault that stops the car immediately, but it is best dealt with soon so as not to stress the battery in hot weather.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EE3 — A/C refrigerant valve B: control circuit open
- Next code: P0EE5 — A/C refrigerant valve B: control circuit high
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high