P0EE6 — A/C refrigerant valve B: driver current or temperature too high
| Meaning | The control unit has detected that the circuit driving refrigerant distribution valve B is drawing too much current or heating beyond its limit. To protect itself, the driver may switch off the command and the valve stops working. Which air conditioning circuit valve B serves depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced battery cooling
Warning light on
Limited power in hot weather
Valve not responding after running for a while
Common causes
Wiring leaking to ground
Mechanically stiff valve forcing higher current draw
Oxidised connector heating up
Faulty or overheated control unit driver
What to do
How to read code P0EE6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EE6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EE6 mean?
A/C refrigerant valve B: driver current or temperature too high. The control unit has detected that the circuit driving refrigerant distribution valve B is drawing too much current or heating beyond its limit. To protect itself, the driver may switch off the command and the valve stops working. Which air conditioning circuit valve B serves depends on the manufacturer.
Can I keep driving with code P0EE6 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EE6
Valve coil partly short-circuited Wiring leaking to ground Mechanically stiff valve forcing higher current draw Oxidised connector heating up Faulty or overheated control unit driver
How do you fix code P0EE6?
Have the coil resistance and wiring of valve B checked first, then check that the valve is not stiff to move. Act soon: a driver working under strain can damage the control unit.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EE5 — A/C refrigerant valve B: control circuit high
- Next code: P0EE7 — Charge port temperature sensor B: circuit fault
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high