P0EE7 — Charge port temperature sensor B: circuit fault
| Meaning | The control unit has detected a problem in the circuit of sensor B, which measures the temperature of the battery charging port. The signal does not match what is expected, so the real temperature of the port is no longer read reliably. Which point of the port is sensor B depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Slower charging than normal
Warning light on
Charging error message on the dashboard
Charge port getting hotter than usual
Common causes
Damaged sensor wiring or connector
Moisture or corrosion in the port
Damaged or worn charge port
Faulty charger control unit
What to do
How to read code P0EE7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0EE7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0EE7 mean?
Charge port temperature sensor B: circuit fault. The control unit has detected a problem in the circuit of sensor B, which measures the temperature of the battery charging port. The signal does not match what is expected, so the real temperature of the port is no longer read reliably. Which point of the port is sensor B depends on the manufacturer.
Can I keep driving with code P0EE7 active?
With caution: limp mode possible, have it checked soon
Common causes — P0EE7
Faulty temperature sensor Damaged sensor wiring or connector Moisture or corrosion in the port Damaged or worn charge port Faulty charger control unit
How do you fix code P0EE7?
Visually inspect the charge port for burn marks, dirt or moisture, and have the sensor and its wiring checked. If you notice a burning smell or unusual heat, stop charging until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0EE6 — A/C refrigerant valve B: driver current or tempera...
- Next code: P0EE8 — Charge port temperature sensor B: signal out of ra...
Related codes
- P0E00 — Generator phase U current sensor circuit fault
- P0E01 — Generator phase U current sensor out of range
- P0E02 — Generator phase U current sensor: signal too low
- P0E03 — Generator phase U current sensor: signal too high
- P0E04 — Generator phase V current sensor circuit fault
- P0E05 — Generator phase V current sensor: signal out of range
- P0E06 — Generator phase V current sensor: signal too low
- P0E07 — Generator phase V current sensor: signal too high
- P0E08 — Generator phase W current sensor circuit fault
- P0E09 — Generator phase W current sensor: signal out of range
- P0E0A — Generator phase W current sensor: signal too low
- P0E0B — Generator phase W current sensor: signal too high