P201E — Cylinder injector circuit fault (ambiguous reference)
| Meaning | The control unit detected a fault in an injector circuit. The reference text is inconsistent: it says cylinder 1 but points to the generic code P0205, which concerns cylinder 5. I can't say for certain which cylinder is involved, so it needs confirming with your make's wiring data. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or vibration
Misfires
Loss of power
Hard starting
Smell of unburnt fuel
Common causes
Damaged injector connector or wiring
Injector coil resistance out of range
Earth or supply problem
Faulty driver stage in the control unit (rare)
What to do
How to read code P201E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P201E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (1E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P201E mean?
Cylinder injector circuit fault (ambiguous reference). The control unit detected a fault in an injector circuit. The reference text is inconsistent: it says cylinder 1 but points to the generic code P0205, which concerns cylinder 5. I can't say for certain which cylinder is involved, so it needs confirming with your make's wiring data.
Can I keep driving with code P201E active?
With caution: limp mode possible, have it checked soon
Common causes — P201E
Faulty injector Damaged injector connector or wiring Injector coil resistance out of range Earth or supply problem Faulty driver stage in the control unit (rare)
How do you fix code P201E?
Have the scan tool identify which cylinder is involved, then check the injector connector, wiring and resistance. If the engine runs unevenly, don't use it for long, to avoid damaging the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P201D — Cylinder 1 injector: circuit or operation fault
- Next code: P201F — Cylinder injector circuit fault (ambiguous referen...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying