P205D — AdBlue tank temperature sensor A: circuit high
| Meaning | The control unit reads too high a voltage on the AdBlue tank temperature sensor circuit. This usually means the circuit is open or the sensor is poorly connected, and the temperature reading is not reliable. The system therefore cannot manage heating and dosing correctly. |
| Family | Powertrain (P) |
Typical symptoms
AdBlue system fault warning
Difficult dosing in cold weather
Possible power limitation
Higher nitrogen oxide emissions
Common causes
Broken sensor wire
Faulty temperature sensor
Damaged wiring near the tank
Control unit fault, less common
What to do
How to read code P205D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P205D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (5D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P205D mean?
AdBlue tank temperature sensor A: circuit high. The control unit reads too high a voltage on the AdBlue tank temperature sensor circuit. This usually means the circuit is open or the sensor is poorly connected, and the temperature reading is not reliable. The system therefore cannot manage heating and dosing correctly.
Can I keep driving with code P205D active?
With caution: limp mode possible, have it checked soon
Common causes — P205D
Sensor connector unplugged or corroded Broken sensor wire Faulty temperature sensor Damaged wiring near the tank Control unit fault, less common
How do you fix code P205D?
Check the sensor connector and wires on the tank, where water and dirt are common. Have it checked soon, as it can lead to restrictions. If the wiring is fine, the sensor is tested by measuring its resistance.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P205C — P205C: reference definition inconsistent, needs ve...
- Next code: P205E — P205E: reference definition inconsistent, needs ve...
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying