Skip to content
Fault code dictionary (DTC)

P2062 — AdBlue supply: control circuit open

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a break in the circuit that controls the delivery of reductant (AdBlue), usually the pump or supply module. The command does not complete the circuit as it should. The system therefore cannot bring AdBlue to the injector.
FamilyPowertrain (P)

Typical symptoms

Engine warning light on
AdBlue system fault warning
No AdBlue consumption
Possible power limitation or restart block
Higher nitrogen oxide emissions

Common causes

Pump or module connector unplugged or corroded
Broken control wire
Faulty pump or supply module
Power fuse or relay
Control unit problem, less common

What to do

Check the fuse, connector and wires of the AdBlue pump, often near the tank. Don't put this off, as the car may limit performance. If the connections are fine, the pump needs testing.

How to read code P2062

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2062 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (62) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2062 mean?

AdBlue supply: control circuit open. The control unit detected a break in the circuit that controls the delivery of reductant (AdBlue), usually the pump or supply module. The command does not complete the circuit as it should. The system therefore cannot bring AdBlue to the injector.

Can I keep driving with code P2062 active?

With caution: limp mode possible, have it checked soon

Common causes — P2062

Pump or module connector unplugged or corroded Broken control wire Faulty pump or supply module Power fuse or relay Control unit problem, less common

How do you fix code P2062?

Check the fuse, connector and wires of the AdBlue pump, often near the tank. Don't put this off, as the car may limit performance. If the connections are fine, the pump needs testing.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes