P2063 — AdBlue supply: control circuit low
| Meaning | The control unit detected too low a voltage in the circuit that controls the delivery of reductant (AdBlue). It generally indicates a short to ground in the wiring or the component. The system cannot get AdBlue to the injector. |
| Family | Powertrain (P) |
Typical symptoms
AdBlue system fault warning
Possible power limitation
Pump not running or stopping immediately
Higher nitrogen oxide emissions
Common causes
Pump or module with a shorted winding
Connector with water or corrosion
Blown fuse
Control unit problem, less common
What to do
How to read code P2063
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2063 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (63) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2063 mean?
AdBlue supply: control circuit low. The control unit detected too low a voltage in the circuit that controls the delivery of reductant (AdBlue). It generally indicates a short to ground in the wiring or the component. The system cannot get AdBlue to the injector.
Can I keep driving with code P2063 active?
With caution: limp mode possible, have it checked soon
Common causes — P2063
Short to ground in the wiring Pump or module with a shorted winding Connector with water or corrosion Blown fuse Control unit problem, less common
How do you fix code P2063?
Check the pump wiring and connector, looking for crushed wires or damaged insulation. If a fuse has blown, find the cause before replacing it. Have the fault checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2062 — AdBlue supply: control circuit open
- Next code: P2064 — AdBlue supply: control circuit high
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying