P2064 — AdBlue supply: control circuit high
| Meaning | The control unit detected too high a voltage in the circuit that controls the delivery of reductant (AdBlue). It may come from contact with a power supply or a problem in the control driver. The pump or module is not being controlled correctly. |
| Family | Powertrain (P) |
Typical symptoms
AdBlue system fault warning
Possible power limitation
Pump always running or not responding
Higher nitrogen oxide emissions
Common causes
Damaged or dirty connector
Faulty pump or supply module
Stuck control relay, if fitted
Internal control unit fault, less common
What to do
How to read code P2064
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2064 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (64) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2064 mean?
AdBlue supply: control circuit high. The control unit detected too high a voltage in the circuit that controls the delivery of reductant (AdBlue). It may come from contact with a power supply or a problem in the control driver. The pump or module is not being controlled correctly.
Can I keep driving with code P2064 active?
With caution: limp mode possible, have it checked soon
Common causes — P2064
Wiring touching a power-supply wire Damaged or dirty connector Faulty pump or supply module Stuck control relay, if fitted Internal control unit fault, less common
How do you fix code P2064?
Check the wiring, connector and any relay of the AdBlue pump. An uncontrolled command can damage the pump, so don't wait too long. If the wiring is intact, an electrical test is needed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2063 — AdBlue supply: control circuit low
- Next code: P2065 — Fuel level sensor B: circuit fault
Related codes
- P2000 — NOx trap efficiency below threshold, bank 1
- P2001 — NOx trap efficiency below threshold, bank 2
- P2002 — Diesel particulate filter (DPF) clogged
- P2003 — Particulate filter efficiency below threshold, bank 2
- P2004 — Intake manifold runner control stuck open, bank 1
- P2005 — Intake runner control stuck open (bank 2)
- P2006 — Intake runner control stuck closed (bank 1)
- P2007 — Intake runner control stuck closed (bank 2)
- P2008 — Intake runner control circuit open (bank 1)
- P2009 — Intake runner control circuit low (bank 1)
- P200A — P200A: meaning is manufacturer dependent, needs verifying
- P200B — P200B: meaning is manufacturer dependent, needs verifying